Michael Butler's Public Library

• Instructions for use: Immediately after bathing and exiting the whirlpool bath, leave the bath water in the tub and add hot water, if necessary, so the water is at least 2" above the highest jet.
• Turn on the unit without the aerator. Pour the contents of the Systems Clean Packet 1 (taking care not to get the material on yourself) into the bath near the intake for the circulation pump.
• Repeat same process with Systems Clean Packet 2. It is important to use Packet 1 before Packet 2 to avoid a strong odor. Run the bath for 5 to 10 minutes. Drain completely and rinse any residue.

• Instructions for use: Immediately after bathing and exiting the whirlpool bath, leave the bath water in the tub and add hot water, if necessary, so the water is at least 2" above the highest jet.
• Turn on the unit without the aerator. Pour the contents of the Systems Clean Packet 1 (taking care not to get the material on yourself) into the bath near the intake for the circulation pump.
• Repeat same process with Systems Clean Packet 2. It is important to use Packet 1 before Packet 2 to avoid a strong odor. Run the bath for 5 to 10 minutes. Drain completely and rinse any residue.

• Instructions for use: Immediately after bathing and exiting the whirlpool bath, leave the bath water in the tub and add hot water, if necessary, so the water is at least 2" above the highest jet.
• Turn on the unit without the aerator. Pour the contents of the Systems Clean Packet 1 (taking care not to get the material on yourself) into the bath near the intake for the circulation pump.
• Repeat same process with Systems Clean Packet 2. It is important to use Packet 1 before Packet 2 to avoid a strong odor. Run the bath for 5 to 10 minutes. Drain completely and rinse any residue.

• Instructions for use: Immediately after bathing and exiting the whirlpool bath, leave the bath water in the tub and add hot water, if necessary, so the water is at least 2" above the highest jet.
• Turn on the unit without the aerator. Pour the contents of the Systems Clean Packet 1 (taking care not to get the material on yourself) into the bath near the intake for the circulation pump.
• Repeat same process with Systems Clean Packet 2. It is important to use Packet 1 before Packet 2 to avoid a strong odor. Run the bath for 5 to 10 minutes. Drain completely and rinse any residue.

• Instructions for use: Immediately after bathing and exiting the whirlpool bath, leave the bath water in the tub and add hot water, if necessary, so the water is at least 2" above the highest jet.
• Turn on the unit without the aerator. Pour the contents of the Systems Clean Packet 1 (taking care not to get the material on yourself) into the bath near the intake for the circulation pump.
• Repeat same process with Systems Clean Packet 2. It is important to use Packet 1 before Packet 2 to avoid a strong odor. Run the bath for 5 to 10 minutes. Drain completely and rinse any residue.

WHIRLPOOL BATHS - Use & Care Questions/Answers

• Be careful when using bubble bath, as the increased agitation of a whirlpool bath will generate many times more bubbles than a conventional bath.
• We recommend that you use non-oil based additives, as they will be easier to clean out of the bath. It is recommended that you purge the whirlpool system
  after every use when using bath additives. The use of certain bath oils, bubble baths and bath additives may increase the level of accumulations of bath residue in the whirlpool system.
• If excess accumulations persist, you should discontinue use of these products. (Please see the answer to the following question for a complete explanation of the purging process)