n the basic 1911 design. This tube contains two little plungers and a spring, the power of which serves both to hold the slide stop in the down position until operated by the follower of the empty magazine as well as to hold the thumb safety lever in the safe or fire position. This is a high-stress area of the gun; every time you flip your thumb safety on or off, you apply force to the plunger tube. Unfortunately, the plunger tube is held to the side of the gun only by two small studs that pass through holes in the frame. It is not at all unusual for one of these studs (almost invariably the rear one) to snap off. I've had this happen myself while shooting, and I've seen it happen to other shooters. When this happens, your thumb-safety lever will wind up in a half-on/half-off position. In an emergency, it would be possible to physically hold the safety lever down in the fire position and still shoot the piece. However, for all practical purposes, the gun is disabled until the plunger tube is replaced.
There's really nothing you can do about this problem except to keep a close eye on your gun's plunger tube for signs of looseness. Some folks say that if your plunger tube is loose, you should simply have it restaked. I don't know about that. If the plunger tube has been loose for any amount of time, that rear stud ha
2" shotshell and .45 Colt Ammunition, this amazing combo gun is ideal for short distances - where most altercations occur, or longer distances with the .45 Colt ammo. We have finely tuned the rifling to spread the shot pattern at close quarters or to guide the .45 cal. bullet to the target. Fully customized with fixed rear sights, fiber optic front sights and Taurus Ribber Grips®, the "Taurus Judge" is one decision-maker that lays down the law.