This link has been bookmarked by 1 people . It was first bookmarked on 28 May 2007, by York Jong.
-
28 May 07
-
attach your Pager Motors to your Popper using two Fuse Clips, two Small Paper Clips, and no solder
-
-
-
Set one straightened paper clip aside, you will use it at the end. Bend the two tips of one of the two paper clips as shown.
-
Put it in through the fuse clip like this, but make sure the notch in the fuse clip is facing out. (The clip has one edge bent inwards. This is the part that has to face outwards). Study this next picture closely.
-
From the position above, bend the paper clip up and then around the lead of the fuse clip as in the next picture.
-
Bend the paper clip under the fuse clip...
-
then up and over the fuse clip:
-
then around its other lead and you're almost done with the first fuse clip.
-
First clip -- wire is on the RIGHT side of the fuse clip leads...
Second Clip -- wire is on the LEFT side of the fuse clip leads... But remember to make sure the notch in the fuse clip is facing out. (The clip has one edge bent inwards. This is the part that has to face outwards).
Follow all the steps above with the second clip and you get this:
-
Would you like to comment?
Join Diigo for a free account, or sign in if you are already a member.